You can read the Ethernet HOWTO which tells you which card uses what drivers.. Just wanted to note that I sometimes get this problem when I disconnect my LAN cable from the ethernet card, As soon as I put the cable back on it works fine. Check this link out, it explains some more...
http://www.linuxmanagers.org/pipermail/linuxmanagers/2002-July/000750.html
Remember Google is your friend...
Regards, Keith
On Wed, 4 Feb 2004, Dilip M wrote:
But i'm using D-Link's DFE-538TX,which redhat "
But by default,when i do 'kudzu' this n/w card gets detected as "eth0: RealTek RTL8139 Fast Ethernet"
RTL8139 is the chip that is used by DLink cards. Most likely you have a problem with your card. Try getting another one.
Philip
-- Where humor is concerned there are no standards -- no one can say what is good or bad, although you can be sure that everyone will. -- John Kenneth Galbraith